SiteService

Alarm monitoring app

With the Danfoss SiteService alarm monitoring app, you can cut down on service visits while maintaining an overview of system operations - saving you time and effort while still providing a top-tier level of service to your clients.

However, this app goes beyond alarm monitoring. SiteService remotely connects to any AK SC 255, AK SC 355, or AK SM 800 series Danfoss control system and gives you a full visualization of live plant status, alarm management, system performance history, and component settings.

You can easily check on and resolve alarms, run a defrost cycle, adjust asset setpoints, and gather information to determine if a site visit is required.

Start cutting down on the frequency of routine on site service visits and emergency service calls by installing SiteService now.

For further information, please contact us.

SiteService ("the Application") is provided on an "as is" and "as available" basis for the intended purposes as determined by Danfoss only and any use hereof is at the user's sole risk. The Application and results and information generated thereby cannot substitute technical advice but must be verified by the user, they are not promises and should not be relied on as accurate data or analyses.

Danfoss disclaims all warranties and conditions regarding the Application, whether express, implied, or statutory, including, but not limited to, conditions of merchantability, satisfactory quality, fitness for a particular purpose, accuracy and non-infringement of third parties' rights. Danfoss does not warrant that the Application will meet your requirements or that the operation hereof will be uninterrupted or error-free.

To the extent not prohibited by law, in no event shall Danfoss be liable for any direct, special, indirect or consequential damages, whatsoever, including, without limitation, damage to property, damages for loss of savings or profits, or loss of data arising out of any use of the Application.